Clark HFC3P Three Channel Hybrid Fiber Camera Cable

Three-Channel Plenum-Rated Hybrid Camera Cable

HFC3P

UL Listed CMP - plenum rated for permanent installation applications

Low-Loss 9u Single-Mode Fiber- high-bandwidth, low-loss type fiber for high data rates

Jacketed Copper Sub Groups - copper elements and grouped and jacketed per camerea position

Numerically Printed Fiber Elements- simplex fibers are numbered for identification

High Tensile Strength Tight Buffer - tripple the tensile strength for added durability

Outer Plenum PVC Jacket - low-friction jacket eases installation in conduit

Clark’s HFC3P is a composite cable that is specifically designed for the distribution of all the copper and fiber elements required for three SMPTE hybrid fiber camera positions within a single cable. Each shielded copper group contains two 18AWG auxiliary conductors and two 24AWG signal conductors with a drain wire for shield termination. The fiber elements consist of six individual simplex single-mode breakout cables that are numerically printed for identification. UL Rated CMP, the HFC3P is constructed from FEP and Plenum PVC compounds to allow for installation in plenum spaces.

Materials & Dimentions

Fiber Elements

(6) 8.9u Single-Mode, 2.0mm Simplex Fiber (Numbered 1 - 6)

Copper Sub Groups

(3) Shielded Bundles that each consist of:

2 - 18AWG (19x30AWG) TC Conductors w/ .068” FEP Insulation

2 - 24AWG (7x32AWG) TC Conductors w/ .044” FEP Insulation

1 - 22AWG (7x30AWG) TC Conductor Drain Wire

100% Foil Overall Shield with Outer Mylar Coating

Plenum PVC Jacket, .188” O.D.

Outer Jacket

Plenum PVC, Yellow w/ Purple Stripe - .490” O.D.

Cross Sectional Diagram

Mechanical Characteristics

Bend Radius	Operating Temperature	Weight	UL Listing
4.9"	-30degC to +75degC	200 lbs	CMP, FT-6

Optical and Electrical Characterisitics

Insulation Resistance

DCR

Dielectric Strength

Optical Attenuation

>10M Ω/Mft

18AWG (19x30): 6.0 Ω/Mft

24AWG (7x32): 23.5 Ω/Mft

3000V RMS

<0.70 dB/km

(1250nm - 1625nm)