Return to the Clark Homepage
 
 


Neutrik SpeakOn Termination Instructions

 

   

 


Cable Preparation



 

NL2FC

Put bushing onto the cable.

Prepare cable as shown above.

   
Insert the wires into the terminals and fasten the clamping device be means of Allankey 1/16" or flat screw driver.
Snap on locking ring into the chuck direction as shown above.
Fasten bushing by means of a fork wrench 11/16".
 
NL4FC
Put bushing and chuck onto the cable
Prepare cable as shown above.

   
Insert the wires into the terminals and fasten the clamping device by means of Allankey 1/16" or flat screw driver.
Push insert and chuck into housing (pay attention to the guiding keyway!).
Fasten bushing by means of a fork wrench 3/4".
NL8FC
Put bushing and chuck onto the cable
Prepare cable as shown above.

  
Insert the wires into the terminals and fasten the clamping device by means of Allankey 1/16" or flat screw driver.
Push insert and chuck into housing (pay attention to the guiding keyway!).
Fasten bushing by means of a fork wrench 3/4".
     




   

SpeakOn® is not to be used as a "main" (AC) Connector
 
Wiring
Positive signal on speaker pin "+" produces positive waveform from driver (moves cone outwardly)
"+" = In phase (high) "-" = Ground (out of phase, low)
Lower numbers for lower frequencies
 
AMPLIFIER CABLE SPEAKER
Stereo
("HiFi")
One NL4MP socket
left channel pins 1+/1-
right channel pins 2+/2-
N 4FC on amplifier end, tour conductor cable splits into two pairs with NL4FC on each end One NL4MP per speaker
left speaker pins 1+/1-
right speaker pins 2+/2-
POWER ("PA")
Standard
Three NL4MP socket
"A" socket:left channel pins 1+/1-
"B" socket:right channel pins 1+/1-
A two-conductor cable for each channel with NL4FC on both ends NL4MP pin+ to speaker coil "+"
NL4MP pins 1- and 2+ to speaker coil "-"
Bridged mono "M" socket:
left channel pins 1+/1-
right channel pins 2+/2-
A special two-conductor cable on both ends wired to pins 1+/1-, 2+/2 of NL4FC NL4MP pin+ to speaker coil "+"
NL4MP pins 1- and 2+ to speaker coil "-"
Bi-Amp One NL4M socket
low frequency pins 1+/1-
high frequency pins 2+/2-
A four-conductor cable, on both ends wired to pins 1+/1-, 2+/2 of NL4FC one NL4MP socket
low frequency pins 1+/1-
high frequency pins 2+/2-

 
 
 
2020 Clark Wire & Cable       1-800-CABLE-IT  (800-222-5348)